All of the same high quality features of our aluminum service truck bodies go into these telescopic boom versions. Starting off on a 26,000 GVWR chassis such as the Ford-F550, Jomac constructs an aluminum service truck body and cabinets built to your specifications. All truck decks are manufactured using 3" channel crossmembers welded on 8" centers, each crossmember fully gusseted for strength and durability. Then, the deck is constructed of 3/16" aluminum diamond plate or if you choose, 1" bar grate. Anodized D-rings are fastened to the deck, optimally located for the securing of your payload. Cabinets are constructed of 1/8" aluminum sheet, reinforced for rigidity, and matching stainless steel lock latches are installed for security and weather resistance. Again with quality in mind, cabinets are fitted with stainless steel hinges, stainless spring door checks, automotive type rubber ball seals and vinyl edge protectors.

Cabinets may be configured in basically any configuration according to your specifications, or you may choose to have the truck constructed as a flatbed if desired.

Telescopic cranes are manufactured in house by Jomac, with performance and function in mind. The STC-80 Series of telescopic cranes utilize a 37,000 ft. lb. hydraulic crane, PTO driven off the truck, allowing for a 100% duty cycle. Crane winch is also hydraulically driven for maximum service. Absolutely no electrically driven pumps or winches are used on our units! Bare drum single line pull on the hydraulic winch is rated at 4,000 lbs. with a line speed of 26 feet per minute. Wire rope (cable) is 3/8" diameter and 75' long.

Cranes may be mounted behind cab or at rear of truck, corner or center mount.